Operating instructions for the Ardo A1000 washing machine

Operating instructions for the Ardo A1000 washing machine

Operating instructions for the Ardo A1000 washing machine

Accessories for washing machine

The water pressure in the water supply network must be in the range of 0.05 - 1.00 mPa (0.5 - 10 bar.)
Before connecting the machine, open the tap and let the water drain so that the pipes are cleared of contaminants such as sand and rust (perform this operation is especially important when the washing machine has not been used for a long time or when it is connected to a kinked water supply line).

The inlet hose must be connected to the cold water tap with a 3/4” threaded fitting.

Place the filter mat included with the machine between the tap and the pipe, and then tighten the connection tightly [Fig. 4].

Place the gasket on the other end of the inlet hose and screw it to the washing machine [Fig. 5].

During washing, the water supply tap must be fully open.

The water drain pipe should be at a height of 60 to 90 cm [Fig. 6].

If water is drained directly into the sewer, the free edge of the washing machine pipe must be inserted into a sewer pipe with an internal diameter of at least 40 mm.

Make sure that the drain pipe of the machine is not tightly inserted into the sewer pipe so that the siphon does not fill with air and, accordingly, there is no overflow of water.

If water is drained into a sink or somewhere else, the free end of the pipe must be secured at the point where it bends with a special holder included with the machine. Thus, place the pipe on the edge of the sink and secure the holder so that the pipe does not fall [Fig. 7]. The sink drainage channel must be clean so that water can flow through it freely.

DESCRIPTION OF THE WASHING MACHINE - CONTROL PANEL

Pre-wash BIO Durable very dirty fabrics (white sheets and permanent dyes)

WOOL WASHING PROGRAMS

compartment for conditioner, fragrance, additives or bleach (3)

WASHING DETERGENTS

The ARDO S 1000 X washing machine is equipped with a drawer for detergents consisting of three compartments [Fig. 10]. The drawer panel contains a description of the programs.

I compartment for detergent powder for pre-wash or soak (1) II compartment for detergent powder for normal washing (2) compartment for softener, fragrance, additives or bleach (3)

In areas with hard water, use anti-scale agent along with detergents, which increases efficiency and improves the quality of washing and at the same time protects machine parts from lime deposits. This product should be placed together with the detergent in the middle compartment (2). ATTENTION: USE powder or liquid detergents for ARDO S 1000 X automatic washing machines for WASHING, as they produce less foam. Put in the machine as much detergent as recommended by the manufacturer on the packaging. Excessive amounts of detergent can cause too much foam to form and negatively affect the wash result. Insufficient amount of detergent may result in unsatisfactory washing results.

SERVICE

The ARDO S 1000 X washing machine is designed to minimize its maintenance. However, it is important to always remember to clean your machine regularly. Before cleaning, make sure that the appliance is disconnected from the electrical network and that the water supply is turned off. ATTENTION !! Do not wash the car with chemical compounds; use only a soft, damp and slightly soapy cloth for cleaning. Cleaning the ARDO S 1000 X washing machine Wipe the outer casing and rubber parts of the machine with a soft damp cloth. Do not use abrasives, gasoline or other solvents. After finishing washing, leave the machine door open for a while to allow the rubber parts to dry. Clean the detergent compartments periodically. To do this, remove the entire drawer and rinse it under running water. Push it into place. Cleaning the filter ATTENTION!! Before you begin the operations described below, make sure that the ARDO S 1000 X washing machine is empty. Do not remove the filter while the machine is running or when the machine tank is full of water. Place a rag or flat tray under the filter to collect any remaining water from the filter. Open the filter cover, unscrew the filter counterclockwise and remove it [Fig. eleven]. The filter must be cleaned periodically. Rinse the filter under running water and clean it of all contaminants. Screw the filter clockwise and check that it is sealed tightly.

Washing machine Ardo A 1000 – instructions for use

the Ardo A 1000 washing machine operating manual in Russian for free from the link below or view the instructions in your browser.

If you have any additional questions about using or repairing the Ardo A 1000 washing machine, you can ask them in the comments at the bottom of the page and via the link - Ask or in the Questions and Answers section.

SOLVING EMERGING PROBLEMS

If the machine does not work, and before contacting an authorized service center, you must check that the cause of the problem is not one of those listed below.

The ardo s 1000 washing machine does not work (the signal light does not light up) • check that: 1) there is voltage in the network 2) the plug is inserted correctly 3) the programming knob is in the on position and that the on/off button is not pressed Washing machine ARDO S 1000 X does not work (signal light is on) • check that: 1) the programming knob is in the position of the selected program; 2) read the instructions section “The ARDO S 1000 X washing machine does not fill with water” The ARDO S 1000 X washing machine does not fill with water • check that: 1) there is water in the water supply 2) the water supply tap is open 3) the inlet hose is not pinched 4) the filter was not clogged. In this case, clean the filter by disconnecting the device from the electrical network 5) there are no hardened residues of washing powder in the drawer The ARDO S 1000 X washing machine continuously fills and drains water • check that: 1) the drain pipe is at the appropriate height (60390 cm) 2 ) the end of the drain pipe is not immersed in water The ARDO S 1000 X washing machine does not drain water and the centrifuge does not operate • check that: 1) the drain pipe is connected correctly 2) the drain pipe is not bent 3) the filter on the drain is not clogged 4) the centrifuge was not turned off 5) the shutdown function with water in the tank was not turned on.

The ARDO S 1000 X washing machine vibrates and makes noise • check that: 1) all transport protections have been removed - see page 3 2) the ARDO S 1000 X washing machine has been leveled 3) bulky items such as sheets, tablecloths, etc. , not the tanks are concentrated in one part of the tanks The door does not open 1) Wait approximately one minute after completing the wash The laundry is not spun sufficiently by the centrifuge • check that: 1) the items are evenly distributed in the tank 2) the appropriate rotation speed of the centrifuge is set Washing machine ARDO S 1000 X stops during washing • check that: 1) the power supply is not interrupted There is too much detergent left in the drawer • check that: 1) the water supply tap is open 2) the filter located between the tap and the water supply pipe is clean After laundry remains dirty • check that: 1) the tank is not overfilled 2) a sufficient amount of detergent has been used 3) the appropriate washing program has been selected The items have shrunk or faded • check that: 1) the correct washing program has been set 2) the correct wash program has been set washing temperature

If, after performing the checks described on the previous page, the device still does not work as expected, report the machine problem to your nearest authorized service center. Please indicate the machine model, manufacture number and type of damage. The device data is given on the information plate located on the filter cover. Such information will help the service technician stock up on the necessary spare parts, which will ensure quick and efficient repairs. It is recommended to always have the following information on hand:

MODEL: ……………………………………………………………….. PRODUCTION NUMBER: ………………………………………………………………. DATE OF PURCHASE: ………………………………………….

TECHNICAL DATA S 1000 X

DIMENSIONS

width - 59.0 cm height - 84.5 cm depth - 39.5 cm

Power supply voltage see rating plate Total power consumption see rating plate Emergency mains switch see rating plate Water pressure min. 0.05 MPa - max. 1 MPa

Recommended maximum load for washing: 5 kg - cotton, linen 2.5 kg - synthetic and delicate fabrics 1 kg - wool

How to call a specialist to your home

You can create a repair request in 2 ways. Firstly, from 8 to 22.00 daily by phone:

+7 (495) 215 – 14 – 41

+7 (903) 722 – 17 – 03

And secondly, using the application form on the website. Please indicate in your request:

• Make and model of the machine.
• Signs of malfunction. For example, the washing machine squeaks when spinning or the washing drum does not rotate.
• The repair time is right for you.
• Name, address, telephone.

On the appointed day of repair, the technician will contact you at the specified number to confirm the time of arrival.

If you are unable to troubleshoot the Ardo A 1000 X washing machine on your own, contact the professionals at the RembytTech workshop! Our knowledge and experience in repairing units of this brand allows us to fix almost any problem right at your home during the first visit. A warranty card valid for up to 2 years is issued for the work done and new spare parts.

Inscriptions on the car and their decoding

The manufacturer of these washing machine models tries to reduce the number of inscriptions as much as possible, so it replaces them with special symbols. And if some of them (usually those that are often used) are easy to remember, then others will require decoding.

Based on the type of model (Ardo A600, TL60e, TL400, and so on), the number of device functions may change, but this does not mean that the decoding also changes. You can find out what this or that inscription means in the instructions.

Explanation of some inscriptions on the Ardo washing machine:

1. Cotton. In this case, there will be a box of so-called cotton on the panel of the washing device. This mode is intended for washing cotton-based items, since this material is not afraid of high temperatures and long washing times. As a rule, the program runs for 145-170 minutes at a temperature of 60-90 degrees.
2. Synthetics. She is depicted in the form of a flask. This mode can wash mixed and synthetic materials at the same time. The wash lasts no more than 127 minutes.
3. Express 20. Thanks to the program, you can quickly (in just 20 minutes) wash any lightly soiled items. The water temperature does not exceed 35 degrees.
4. Wool. The icon looks like a ball of thread. This mode is designed for washing wool at low temperatures.
5. Handwash. Gentle mode that perfectly cares for delicate clothes. The washing time in this case is 100 minutes.
6. Daily. The mode is represented by a T-shirt symbol on the car panel. Using this mode, you can wash things every day, as it wastes a minimum of water and energy. Washing takes no more than half an hour.
7. Sportswear. Washing is carried out at 40 degrees, which allows you to preserve the shape and color of things. Thanks to the program, clothes do not need to be ironed after drying.
8. JEANS mode. Thanks to the low temperature of 40 degrees, it will be possible to avoid discoloration and protect your jeans from shedding. Washing time averages 70 minutes.
9. Spin. If necessary, you can turn it off, or you can select 2 spins, which will allow you to spin the washed items better.

These programs are present on almost every model of Ardo washing machine. Before starting the wash, it is recommended that you read the instructions to learn about all the nuances of the operation of household appliances.